PERMABOND TA4611 2 PART ADHESIVE 25ml

Adhesion to a wide variety of substrates
Full cure at room temperature
Bonds polyolefins
No primer required
Good impact strength
Good chemical resistance

Description
PERMABOND® TA4611 is a 2-part, 1:1 toughened acrylic adhesive. It has been developed to bond low surface energy plastics such as polypropylene and polyethylene – with no primer or expensive surface treatment required. It can also be used to bond a wide variety of other materials such as metals and composite materials and is ideal for bonding dissimilar surfaces. This product is similar to TA4610 but does not contain micro beads making it suitable for joints with smaller gaps.

Surface Preparation
Surfaces should be clean, dry and grease-free before applying the adhesive. Polyolefin surfaces may have traces of mold release agent present – wipe with isopropanol (IPA) solvent and allow to fully evaporate before bonding. If bonding to metal: some metals such as aluminium, copper and its alloys will benefit from light abrasion with emery cloth (or similar) to remove the oxide layer.

Directions for Use
1) Surfaces must be clean, dry and grease-free prior to bonding. 2) Apply a thin bead of adhesive pre-mixed through a static mixer nozzle. 3) Assemble components and clamp. 4) Maintain pressure until handling strength is achieved. The time required will vary according to the joint design and surfaces being bonded. 5) Allow 24-36 hours for adhesive to fully cure. NB: Adhesive outside of a closed joint (i.e. excess material) will cure more slowly and may feel soft due to air contact. Adhesive inside the joint will cure solid.